How to Setup Your Nebo Slider


Step By Step Instructions

  1. Screw the center mount onto your tripod.

  2. Thread the carbon fiber rails onto the tripod.

  3. Slide the sled onto the rail system.

  4. Loosen the T-handle screws on each end piece.

  5. Slide each end piece onto the rails.

  6. Tighten the T-handle screws on the end pieces to lock them in place.

  7. Loop the paracord through the sled and into the cord locks.

  8. Wrap the paracord one and a half times around the pulley attached to the motor (see video).

  9. Loop the paracord around the non-motorized end piece.

  10. Tighten the paracord using the cord locks.

  11. Control the slider movement by using the on/off switch, direction switch, and speed control knob.

  12. Shoot some amazing content with the Nebo Slider.
     

Setup Tips


  • Always wrap the paracord around the motorized pulley one and a half times. This makes it so the paracord won't slip when you are operating the Nebo Slider at an incline.

  • Move the cord locks as close the sled as possible to get the most movement out of the Nebo Slider.

  • When using the Nebo Slider at an incline with one side on the ground use the non-motorized end as the end that is in contact with the ground.

  • If your are doing a night time lapse use the Nebo Slider at the slowest speed.


How to replace the battery